Getting Started - Constructing Peripheral Registers from Memory Addresses
-
Downloading our Integrated Development Environment (IDE) (2:34)
-
Installing our Integrated Development Environment (IDE) (2:38)
-
Getting the right Documentation for Bare-Metal Development (6:10)
-
Coding : Locating the Ports and Pins of Components on the Nucleo board (8:25)
-
Coding : Defining Addresses of Modules using information from the Documentation (20:17)
-
Coding : Creating required Registers using Information from Documentation (21:03)
-
Coding : Configuring Pins using the Registers we Created (9:10)
-
Coding : Creating Registers from Structure Members (23:00)
General Purpose Input/Output(GPIO)
Universal Asynchronous Receiver-Transmitter (UART)
-
Overview of the UART Protocol (7:43)
-
Coding : Developing the UART Transmitter Driver (31:52)
-
Coding : Testing the UART Transmitter Driver (12:24)
-
Coding : Retargeting printf (3:13)
-
Coding : Making the UART TX Driver more Modular (4:41)
-
Coding : Developing the UART Receiver Driver (10:59)
-
Coding : Testing the UART Receiver Driver (4:42)
Analog to Digital Conversion (ADC)
-
Introduction to Analog to Digital Conversion (4:02)
-
Understanding ADC Independents Modes (8:38)
-
Coding : Developing the ADC Driver - Pt.1 Locating the ADC Bus (9:07)
-
Coding : Developing the ADC Driver - Pt.2 Implementing the ADC Init Function (24:14)
-
Coding : Developing the ADC Driver - Pt.3 Testing the ADC Driver (9:52)
-
Coding : Developing the ADC Single Conversion Driver (2:20)
The System Tick (SysTick) Timer
General Purpose Timers
Interrupts Programming
Inter-Integrated Circuit (I2C)
Serial Peripheral Interface (SPI)
Closing
