Introduction
Course Introduction & KiCad Installation
The PCB Design Flow
-
Overview of KiCad (3:12)
-
Getting Started with the Schematic Editor (9:53)
-
Adding more Components to the Schematics (10:36)
-
Connecting Wires and Annotating Schematics (10:18)
-
Handling Errors (5:22)
-
Assigning Footprints (9:22)
-
Introduction to the PCB Editor (11:07)
-
Creating the Board Outline and Downloading 3D Models (11:14)
-
Adding Copper Pour and Routing the Board (11:45)
-
Adding Silkscreen (2:57)
Analyzing the Documentation
Part Selection Using Distributors
Schematic Design for Power Supply (Regulator)
The Mincrocontroller(MCU)
-
Adding Decoupling Capacitors(Pt.1) (10:12)
-
Overview of the STM32CubeMX (7:48)
-
Adding Decoupling Capacitors(Pt.2) (2:56)
-
Decoupling VDDA and CAP1 (10:09)
-
Adding a Pushbutton for RESET (6:11)
-
Connecting the BOOT0 Pin (6:22)
-
Connecting the Crystal Oscillator(Pt.1) (10:45)
-
Connecting the Crystal Oscillator(Pt.2) (6:55)
-
Connecting the LED & User Pushbutton (6:47)
The Debugger and the USB
The Accelerometer
Exposing Connectors and Cleaning Up
Schematic Annotation and Footprint Assignment
The PCB
The PCB Routing
-
Routing Decoupling Capacitors and Adding Copper Pour for VCC (9:31)
-
Copper Pour on F.CU In1.CU In2.CU and B.CU (4:51)
-
Routing the ADXL345 accelerometer (10:19)
-
Routing Connectors and Adding Ground Vias (9:39)
-
Routing Crystal and VDDA (9:24)
-
Routing other Signals (10:47)
-
Routing the Crystal (10:48)
-
Removing Copper Under Crsytal (2:36)
Adding Silk Screen and Finishing Touches
Getting the Board Manufactured
