Autoplay
Autocomplete
Previous Lesson
Complete and Continue
Printed Circuit Board (PCB) Design from the Ground Up ™
Introduction
Welcome (7:49)
Course Introduction (4:46)
Setting Up
Installing Kicad (3:32)
Getting the Required Documents (4:57)
The PCB Design Flow: Schematics to PCB Layout
Overview of Kicad (3:12)
Getting Started with the Schematic Editor (9:53)
Adding More Components to the Schematic (10:36)
Connecting Wires and Annotating Schematics (10:18)
Dealing with Errors (5:22)
Reading Documentations
Reading the Application Notes(AN4488) (10:16)
Reading the ADXL345 Datasheet (3:24)
Reading the AN2867 Datasheet( Oscillator Design) (11:13)
Part Selection Using Distributors
Searching for Components from Mouser (8:36)
Searching for Components from Digikey (5:39)
Looking at the AMS1117-3.3 Regulator (4:54)
Schematic Design for Power Supply (Regulator)
The AMS1117 3V3 Regulator (Pt1.) (9:41)
Creating the Schematics (8:50)
The AMS1117 3V3 Regulator (Pt2.) (7:20)
The Mincrocontroller(MCU)
Overview of the STM32CubeMX (7:48)
Adding Decoupling Capacitors(Pt.1) (10:12)
Adding Decoupling Capacitors(Pt.2) (2:56)
Decoupling VDDA and CAP1 (10:09)
Adding a Pushbutton for RESET (6:11)
Connecting the BOOT0 Pin (6:22)
Connecting the Crystal Oscillator(Pt.1) (10:45)
Connecting the Crystal Oscillator(Pt.2) (6:55)
Connecting the LED & User Pushbutton (6:47)
The Debugger and the USB
Connecting the Serial Wire Debugger Lines (11:37)
Connecting the USB Lines (11:35)
Adding ESD Protection Diode (8:06)
The Accelerometer
Downloading Component from SnapEDA (10:53)
Adding the ADXL345 Accelerometer (Pt.1) (10:10)
Adding the ADXL345 Accelerometer (Pt.2) (8:51)
Exposing Connectors and Cleaning Up
Adding Connectors to the Schematics (6:36)
Adding Texts and Bounding Boxes (6:36)
Schematic Annotation and Footprint Assignment
Assigning the Footprints (11:31)
Annotating the Schematics (9:59)
Teach online with
Searching for Components from Digikey
Lesson content locked
If you're already enrolled,
you'll need to login
.
Enroll in Course to Unlock