Introduction
Developing some System Drivers for Implementing Real World Examples
-
Programming : Enabling the Floating Point Unit (FPU) (18:00)
-
Programming : Developing a UART Driver - Analyzing the Documentation (11:35)
-
Programming : Developing a UART Driver - Listing out the steps (4:00)
-
Programming : Developing a UART Driver - Implementing the Initialization functi (22:13)
-
Programming : Developing a UART Driver - Implementing the Write function (5:39)
-
Programming : Developing a UART Driver - Testing the Driver (6:39)
-
Programming : Developing the System Timebase - Analyzing the Documentation (8:28)
-
Programming : Developing the System Timebase - Implementing the Init. function (9:52)
-
Programming : Implementing the rest of the timebase functions (12:15)
-
Programming : Testing the timebase (5:34)
-
Programming : System BSP- Listing out the required functions (7:55)
-
Programming : System BSP- Implementing the LED driver (5:01)
-
Programming : System BSP- Implementing the PushButton driver (4:00)
-
Programming : System BSP- Testing (3:35)
-
Programming : ADC Driver- Analyzing the documentations (5:21)
-
Programming : ADC Driver- Listing out the steps (5:27)
-
Programming : ADC Driver- Implementing the Init. functions (13:21)
-
Programming : ADC Driver- Implementing the ADC Read function (14:05)
-
Source Code Download
Introduction to Radio Frequency Identification (RFID)
The RFID Architecture
Introduction to Near Field Communication(NFC)
Working with MIFARE Card and Chips
Developing the MFRC522 Communication Driver
Developing a Library for MFRC522 and MIFARE PICC
-
Overview (4:19)
-
Programming: Defining Macros to hold the MFRC522 Registers and MIFARE Card Commands (8:05)
-
Programming: Configuring the CS and RST Lines (4:00)
-
Programming: Implementing the mfrc522_pins_initialization() Function (1:44)
-
Programming: Implementing the Register Read and Write Functions (7:48)
-
Programming: Setting and Clearing Registers (1:04)
-
Programming Configuring the MFRC522 Initialization Parameters (7:31)
-
Programming: Implementing the antenna_on() and antenna_off() Functions (3:39)
-
Programming: Handling Communication with the NFC Cards (11:04)
-
Programming: Performing Anti-Collision_Procedure (3:18)
-
Programming: Calculating the CRC (4:12)
-
Programming: Selecting a Card (2:17)
-
Programming: Authenticating the Card (2:48)
-
Programming: Reading Data from the Card (1:51)
-
Programming: Writing Data to the Card (2:28)
-
Programming: Implementing the Halt Function (0:45)
-
Programming: Comparing Card IDs (1:47)
-
Programming: Requesting and Detecting Card Presence (2:56)
-
Programming: Exposing the Function Prototypes (5:31)
Developing NFC Applications
