Getting Started - Constructing Peripheral Registers from Memory Addresses
-
Downloading our Integrated Development Environment (IDE) (2:34)
-
Installing our Integrated Development Environment (IDE) (2:38)
-
Getting the right Documentation for Bare-Metal Development (7:41)
-
Coding : Locating the Ports and Pins of Components on the Nucleo board (14:27)
-
Coding : Defining Addresses of Modules using information from the Documentation (14:51)
-
Coding : Creating required Registers using Information from Documentation (28:27)
-
Coding : Configuring Pins using the Registers we Created (12:07)
-
Coding : Creating Registers from Structure Members (34:48)
General Purpose Input/Output(GPIO)
Universal Asynchronous Receiver-Transmitter(UART)
-
Overview of the UART Protocol (7:43)
-
Coding : Developing the UART Transmitter Driver- Pt.1 Pins and Bus Connection (12:49)
-
Coding : Developing the UART Transmitter Driver- Pt.2 Configuring Pin Mode (41:51)
-
Coding : Developing the UART Transmitter Driver- Pt.3 Pin Alternate Function (11:24)
-
Coding : Developing the UART Transmitter Driver- Pt.4 UART Parameters (13:39)
-
Coding : Developing the UART Transmitter Driver- Pt.5 UART Baudrate (11:12)
-
Coding : Developing the UART Transmitter Driver- Pt.6 Testing the UART TX Driver (19:36)
-
Coding : Retargeting printf (3:47)
-
Coding : Making the UART TX Driver more Modular (16:43)
-
Coding : Developing the UART RX Driver (14:02)
-
Coding : Testing the UART RX Driver (24:25)
Analog to Digital Conversion (ADC)
-
Introduction to Analog to Digital Conversion (4:02)
-
Understanding ADC Independents Modes (8:38)
-
Coding : Developing the ADC Driver - Pt.1 Locating the ADC Bus (10:08)
-
Coding : Developing the ADC Driver - Pt.2 Implementing the ADC Init Function (21:11)
-
Coding : Developing the ADC Driver - Pt.3 Testing the ADC Driver (6:44)
-
15_Developing_the_adc_single_conversion_driver (6:34)
The System Tick (SysTick) Timer
General Purpose Timers
Interrupts Programming
-
Introduction to Interrupts (19:44)
-
Coding : Developing the GPIO Interrupt Driver (16:29)
-
Coding : Testing the GPIO Interrupt Driver (8:14)
-
Coding : Developing the Timer Interrupt Driver (17:41)
-
Coding : Developing the Systick Interrupt Driver (8:24)
-
Coding : Developing the ADC Interrupt Driver (13:50)
-
Coding : Developing the UART Receiver Interrupt Driver (11:00)
-
Coding : Developing the UART Transmitter Interrupt Driver (12:57)
Inter-Integrated Circuit (I2C)
Serial Peripheral Interface (SPI)
Closing
